APC-43 CS500, Savi Wireless EHS Cable Cisco IP Phone

APC-43 CS500, Savi Wireless EHS Cable Cisco IP Phone
Move your mouse over image or click to enlarge
APC-43 CS500, Savi Wireless EHS Cable Cisco IP Phone
  • Model: 38350-13
  • Manufactured by: Plantronics

HK$624.00  HK$468.00


5 reward points
Add to Cart:

Special Offers

This is the Plantronics APC-43 EHS (replaces APC-42) Electronic Hookswitch (EHS) cable for Cisco IP Phones.  The Plantronics APC-43 is compatible with these Plantronics wireless headset models:

Plantronics CS540CS510CS520 Plantronics Savi W740,  Plantronics Savi W710 , Plantronics Savi W720 ,  Plantronics Savi W730 ,  Plantronics Savi W745Plantronics Legend CS

 

This EHS adapter only works with the following Cisco IP phones:

 

Cisco phone model 6945, 7821, 7841, 7861, 7942G, 7945G, 7962G, 7965G, 7975G, 8811, 8841, 8851, 8961, 8961, 9951, 9971

Also compatible with Panasonic KX-UTG300/200 phones

 

Cisco IP 8961 9951 9971, you need the APU-72  instead

If you have Cisco 8941, 8945, 8945G use Plantronics APC-82 instead

Note: Do not order this part if you don't have the listed Cisco phone models

Cisco phone setup:

* The phone must be set for “Wireless Headset Hookswitch Control” = Enabled

* Press the settings button on the phone (Checkbox Icon). Select “Device Configuration” >> Select “Media Configuration”

* If “Wireless Headset Hookswitch Control” is “Disabled”, follow the instructions below

Enabling Cisco wireless headset EHS hookswitch control:

Access the Cisco server administrator with a browser.  Select Device>Phone through the drop down menus.  Click "Find" with no selection criteria to obtain a list of all phones
Open the desired phone.  Scroll down to "Wireless Headset Hookswitch Control"  Set to "Enabled" Click "Apply".  Wait for the dialog box to appear, then reset the phone by clicking the reset button.

Plantroincs APC-42

If your Cisco phone is equipped with the Cisco 7914, 7915, 7916 expansion module:

  • Plug the expansion module into the telephone AUX connector.
  • Connect the APC-42 into the expansion module.
  • Use 85638-01 (formerly 40287-05) adapter to extend the APC-42 audio input to reach the headset jack on the phone. See below:

Cisco Expansion Module EHS Setup